Setting Up Your XETA Network

Setting Up Your XETA Network

XETA Network Setup Instructions

Getting your XETA Network up and running is incredibly simple:

  1. Power up your XETA router using the included power supply.
  2. Connect to your modem by plugging the Silver WAN/LAN (10GbE) port on your XETA router into your ISP modem.
  3. Connect to the setup network by finding and connecting to the WiFi network labeled "SetupMyRouter_0123" (numbers will vary) on your laptop or mobile phone.
  4. Complete the setup by scanning the QR code on the bottom of your XETA router with your phone and following the simple step-by-step instructions.
     

That's it - you're all set!

Adding an extender? Easy!

  1. Position your extender in your desired location (like a second floor) for maximum coverage, then power it on with the included supply.
  2. Press the WPS button - find the small white "WPS" button above the ethernet ports on your main router and press it once. It will start blinking white.
  3. Connect the extender by pressing the same WPS button on your extender within 30 seconds. The device will begin blinking green.
  4. Relax for 15 minutes while your devices automatically sync together.
      

Optional Improvements

Want to squeeze out even more performance?

a) Turn off your old WiFi - Disable WiFi on your ISP's modem/router to prevent interference and maximize XETA's speed.

b) Ask about bridge mode - Contact your ISP to see if their modem supports "bridge mode" so your XETA router gets a public IP address (better for streaming and gaming).